|
|
Build Your Online Product Catalogs?
| Product Name: |
2 phase matched driver for stepper motor SH20822M
|
| Supply Ability: |
|
| Related proudcts |
|
| Specifications |
stepper driver,stepping driver,matched driver SH20822M,2 Phase Stepper Motor Driver |
| Price Term: |
|
| Port of loading: |
|
| Minimum Order |
|
| Unit Price: |
|
|
SH20822M
Stepping Motor Driver
I、Summarize
Based on the original stepping motor driver, we developed the 20822M type stepping motor driver. This driver owns many advantages such as lower noise, higher efficiency, lower temperature rise, convenient settings, nicer running characteristic and so on.?
II、The using and instruction of the motor driver.
Input power wiring point:
Single external power supply: AC110V-220V or DC 150V-300V 3A.
Warning: The value of the power supply shouldn’t be over this range.
For two-phase four-wire motor?
Phase
A+
A-
B+
B-
Wire
Red
Green
Yellow
Blue
For four-phase six-wire motor:
Phase
A+
A-
NC
B+
B-
Wire
Red
Green
White Black
Yellow
Blue
For four-phase eight-wire motor, there are two modes
i. Parallel-wound
Phase
A+
A-
B+
B-
Wire
Red Blue
Yellow Black
White Brown
Green Orange
ii. Series-wound
Phase
A+
A-
Nc1
B+
B-
Nc2
Wire
Red
Black
Yellow Blue
White
Green
Brown Orange
Warning：Motor’s wires mustn’t be connected wrongly, Otherwise, the driver will be mangled.
Input signals
The inner interface circuits of the CF20611D are segregated by optically coupled isolators.
There are three connecting mode between the controller and the driver.
i. Differential ?Common-anode
DIR：Input port of the direction signal. High/low level controls the CW/CCW of motor. The changing edge of the signal must be at least 2.5us later or earlier than the falling edge of CP;
FREE: Free signal (active low). when this input end is low level，there will be no holding torque of the motor.
CP：Pulse signal input. active by the falling edge，the highest response frequency can be 200kHz，low level pulse width should be not less than 2.5us?
Warning：Input signal must have enough current, (Currently, TTL, COMS signal are not drive firsthand). Otherwise, System can not run normally.
* phase current and subdivision number setting?
Shift switc |
| Company: |
CHANGZHOU CHANGFENG MOTOR CO., LTD
|
| Contact: |
Ms. Wenyuan Shi |
| Address: |
Building 5, CaiLing Technology Park, No.38, FengHuang Road, ChangZhou, JiangSu, China |
| Postcode: |
213018 |
| Tel: |
86-0519-68688388 |
| Fax: |
86-0519-68688399 |
| E-mail: |
|
|
|
|
Home
